HUSABERG FE 450 AUS, Repair Manual

Page: 197 / 285

FAULT CODE
195
Flash code FI warning
lamp (MIL)
33 FI warning lamp ( MIL ) flashes 3x long, 3x short
Display on diagnostic tool P0201
"Injection valve cylinder 1"
"Malfunction in the circuit"
Error level condition
Malfunction in the circuit:
≥
0.2 s
Function check Injection valve - checking the actuation ( p. 195)
Possible cause Injection valve - value not plausible ( p. 195)
Injection valve - power supply is faulty ( p. 196)
Injection valve - control line has a short circuit to plus (terminal 30) ( p. 196)
Injection valve - control line has a short circuit to ignition plus (terminal 15) ( p. 197)
Injection valve - control line has a short circuit to the sensor power supply ( p. 197)
Injection valve - control line is open ( p. 197)
Injection valve - control line has a short circuit to ground (terminal 31) ( p. 198)
Injection valve - control line has a short circuit to sensor ground ( p. 198)
Injection valve - checking the actuation
Condition
The diagnostic tool is connected and active.
–
Select the model type.
–
Select "ECU Diagnostic" .
–
Highlight the "Engine electronics EXC" control unit.
–
Press "Continue" .
–
Select "actuator test" .
–
"Please enter password:"
–
Press "Continue" .
–
Select "Injection valve cylinder 1" .
–
Press "Continue" .
–
Read the information page in the HUSABERG diagnostic tool and, with "Continue" , begin the actuator test.
Injection valve Function noise
» If the specification is attained:
–
Delete the fault code.
–
Make a test ride.
–
Read out the fault code.
» If the displayed value is not equal to the setpoint value:
–
Check the next possible cause:
Injection valve - value not plausible (
p. 195)
Injection valve - value not plausible
Condition
Th e diagnostic tool is disconnected.
The injection valve is disconnected.
400598-10
Injection valve - check the resistance
–
Measure the resistance between the specified points.
Injection valve Pin
1
–
Injection valve Pin
2
Injection valve
Resistance at: 20 °C (68 °F) 10.5… 13.0
Ω
» If the measured value does not correspond to the specified value:
–
Change the injection valve.
» If the measured value corresponds to the specified value:
–
Check the next possible cause:
Injection valve - power supply is faulty (
p. 196)