HUSABERG FE 450 AUS, Repair Manual

Page: 28 / 285

01/FORK, TRIPLE CLAMP
26
200744-10
–
Push the outer tube upward.
–
Clamp the outer tube in the area of lower triple clamp.
Clamping stand (T1403S) ( p. 277)
–
Grease the Preload Adjuster O-ring.
Lubricant (T158) ( p. 265)
–
Screw on and tighten the Preload Adjuster .
Guideline
Preload Adjuster on the outer tube M51x1.5 50 Nm
(36.9 lbf ft)
Pin wrench (T103) ( p. 274)
200745-10
Alternative 1
–
Turn the compression damping adjusting screw

and the adjusting screw of
the rebound stage

clockwise all the way.
–
Turn back counterclockwise by the number of clicks corresponding to the fork
type.
Guideline
Rebound damping
Comfort 22 clicks
Standard 20 clicks
Sport 18 clicks
Compression damping
Comfort 26 clicks
Standard 22 clicks
Sport 18 clicks
–
Turn the adjusting screw of the spring preload

counterclockwise all the way.
–
Turn back clockwise the number of turns corresponding to the fork type.
Guideline
Spring preload - Preload Adjuster
Comfort 0 turn
Standard 2 turns
Sport 4 turns
Alternative 2
Warning
Danger of accidents
Modifications to the chassis can seriously alter the
vehicle's handling characteristics.
–
Extreme modifications to the adjustment of the spring elements can
cause a serious deterioration in the handling characteristics and
overload some components.
–
Make settings within the recommended range only.
–
Following modifications, ride slowly at first to get the feel of the new
handling characteristics.
–
Set the adjusting screws to the position determined before removal.
–
Mount protective cover

.