HUSABERG FE 450 AUS, Repair Manual

Page: 215 / 285

FAULT CODE
213
Flash code FI warning
lamp (MIL)
15 FI warning lamp ( MIL ) flashes 1x long, 5x short
Display on diagnostic tool P1631
"Rollover sensor (A/D type)"
"Input signal too low"
Error level condition
Signal voltage
"(A/D type)"
:
≤
0.176 V
Time:
≥
3 s
Function check Checking the rollover sensor ( p. 213)
Possible cause Rollover sensor - signal line has a short circuit to ground (terminal 31) ( p. 213)
Rollover sensor - signal line has a short circuit to sensor ground ( p. 214)
Rollover sensor - power supply is open ( p. 214)
Checking the rollover sensor
Condition
The diagnostic tool is connected and active.
–
Select the model type.
–
Select "ECU Diagnostic" .
–
Highlight the "Engine electronics EXC" control unit.
–
Press "Continue" .
–
Select "Measurement values" .
–
Highlight "Starter" .
–
Press "Continue" .
–
Highlight the measured value "Rollover sensor voltage (RolloverAD)" and deselect the other parameters with "Select measured value" .
Info
Deselecting the other parameters improves the quality of the selected parameters (faster data transmission due to smaller
data volume).
Roll angle sensor
Voltage "Standard" 0.4… 1.4 V
Voltage
"Drop detected"
3.7… 4.1 V
» If the displayed value is equal to the setpoint value:
–
Delete the fault code.
–
Make a test ride.
–
Read out the fault code.
» If the displayed value is below the setpoint value:
–
Check the next possible cause:
Rollover sensor - signal line has a short circuit to ground (terminal 31) (
p. 213)
Rollover sensor - signal line has a short circuit to ground (terminal 31)
Condition
Th e diagnostic tool is disconnected.
The EFI control unit is disconnected.
The breakout box is connected to the wiring harness.
The rollover sensor is disconnected.