HUSABERG FE 450 AUS, Repair Manual

Page: 91 / 285

14/LIGHTING SYSTEM, INSTRUMENTS
89
100461-10
–
Wrap rubber band

around the fork legs and close it.
The wiring harness and brake line

are routed in front of the headlight mask.
–
Check the headlight adjustment. ( p. 89)
16.8
Checking the headlight adjustment (FE EU, FE AUS)
0 0 B B
0 0 A A
400558-10
–
On a light-colored wall behind a horizontal area, make a mark as high as the center
of the headlight.
–
Make another mark a distance

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Stand the motorcycle at distance

in from of the wall and switch on the low
beam.
Guideline
Distance

5 m (16 ft)
–
Check the headlight adjustment.
The border between light and dark must be exactly at the lower mark when the
motorcycle is operational and complete with rider.
» If the boundary between light and dark does not meet specifications:
–
Adjust the beam width of the headlight. ( p. 89)
16.9
Adjusting the beam width of the headlight (FE EU, FE AUS)
–
Check the headlight adjustment. ( p. 89)
100459-10
–
Adjust the beam width of the headlight by turning adjusting screw

.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (mark is applied under: Checking the headlight adjust-
ment).
Info
Turn clockwise to increase the beam width, turn counterclockwise to reduce
the beam width.
If you have a payload, you may have to correct the headlight beam width.
16.10
Changing the headlight bulb (FE EU, FE AUS)
Note
Damage to reflector Reduced luminance.
–
Grease on the bulb will evaporate due to the heat and be deposited on the reflector. Clean the bulb and keep it free of grease
before mounting.
–
Remove the headlight mask with the headlight. ( p. 88)
100462-10
–
Turn rubber cap

together with the underlying bulb socket counterclockwise all
the way and remove it.
–
Pull lamp socket

of the parking light out of the reflector.