HUSABERG FE 450 AUS, Repair Manual

Page: 62 / 285

07/FUEL TANK, SEAT, TRIM
60
100434-10
–
Detach connector

of the fuel pump.
100435-10
–
Thoroughly clean the plug-in connection

of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line will clog the fuel injection jets.
–
Disconnect the plug-in connection of the fuel line.
–
Mount wash cap set

.
Wash cap set (81212016000)
–
Carefully raise the fuel tank while detaching intake flange

.
100436-10
–
Carefully close intake trumpet

and connection

of the engine housing vent to
prevent dirt from entering.
10.4
Installing the fuel tank
Danger
Fire hazard Fuel is highly flammable.
–
Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
Warning
Danger of poisoning
Fuel is poisonous and a health hazard.
–
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
–
Clean all parts well.
100438-10
–
Position the fuel tank and route the fuel line to the front.
–
Route the fuel pump cable up through the rear opening in the fuel tank and posi-
tion the fuel tank in its final location.
–
Pull intake flange

through the front opening in the fuel tank and position it.
–
Attach connector

of the fuel pump.