HUSABERG FE 450 AUS, Repair Manual

Page: 120 / 285

30/ENGINE - WORK ON THE INDIVIDUAL PARTS
118
200214-10
–
Mount bearing

and connecting rod

.
Info
Thoroughly oil the bearing.
200215-10
–
Position special tools

and

on the press.
Pressing device for crankshaft, complete (75029047000) ( p. 270)
Insert for crankshaft pressing device (78029008000) ( p. 272)
–
Insert the crank web with the connecting rod and bearing. Position the second
crank web.
200216-10
–
Insert special tool

.
Insert for crankshaft pressing device (78029008000) ( p. 272)
Info
The flat surface of the special tool must face upward.
200209-10
–
Press the upper crank web all the way in.
Info
The press mandrel must be positioned over the crank pin.
–
Take the crankshaft out of the special tool and check that the connecting rod can
move freely.
300609-10
–
Crankshaft - measure the outer dimension of the crank web.
Crankshaft - crank web outer dimen-
sions 63±0.05 mm (2.48±0.002 in)
» If the measured value is less than the specification:
–
Correct it so the dimension is equal to the specified value.
–
Measure end play

between the connecting rod and the crank web.
Feeler gauge (59029041100) ( p. 269)
Connecting rod - end play of lower con-
rod bearing 0.40… 0.60 mm (0.0157…
0.0236 in)
» If the measured value is less than the specification:
–
Correct it so the dimension is equal to the specified value.
–
Check the crankshaft run-out at the bearing pin. ( p. 119)