HUSABERG FE 450 AUS, Repair Manual

Page: 145 / 285

30/ENGINE ASSEMBLY
143
20.21
Installing the clutch cover
300320-11
–
Mount dowels

. Put clutch cover gasket

in place.
300319-11
–
Mount the clutch cover.
Info
Turn the water pump impeller slightly in order to engage the water pump
drive.
–
Mount screws

and tighten once all of the clutch cover screws have been
mounted.
Guideline
Screw, clutch cover M6x25 10 Nm (7.4 lbf ft)
–
Mount screws

and tighten once all of the clutch cover screws have been
mounted.
Guideline
Screw, clutch cover M6x30 10 Nm (7.4 lbf ft)
–
Mount screw

and tighten all screws in a crisscross pattern.
Guideline
Screw, clutch cover M6x65 10 Nm (7.4 lbf ft)
–
Position the crankshaft at top dead center (TDC) and block using the special tool.
Crankshaft locking bolt (113080802) ( p. 267)
20.22
Installing the water pump cover
300318-11
–
Put the water pump cover seal in place.
–
Put the water pump cover on. Mount screws

and tighten once all of the water
pump cover screws have been mounted.
Guideline
Screw, water pump cover M6x25 10 Nm (7.4 lbf ft)
–
Mount screw

and tighten all screws in a crisscross pattern.
Guideline
Screw, water pump cover M6x55 10 Nm (7.4 lbf ft)
20.23
Installing the ignition pulse generator
300317-10
–
Position the ignition pulse generator.
–
Mount and tighten screws

.
Guideline
Screw, ignition pulse gen-
erator M5 6 Nm
(4.4 lbf ft)
Loctite ® 243™
–
Position the cable and insert the cable support sleeve into the engine case.