8.4 Cleaning the machine after operation
For the machine to be in proper technical condition, it must also be clean. In particular, the
interior of the machine should not be heavily contaminated with oil.
When cleaning the interior of the machine using a high-pressure washer, appropriate meas‐
ures must be taken for effective protection of the electrical components from jet water.
➤ The machine must be cleaned by authorised and trained personnel only!
Cleaning by means of dry-ice blasting is strictly prohibited! This can result in unforeseen
damage.
Material Eye protection
Cleaning cloth
Cleaning agents
High-pressure washer
Precondition The machine is standing in a cleaning area equipped with an oil separator,
the machine is standing on level ground and has cooled down.
The machine is fully vented,
the pressure gauge reads 0 bar!
The Controller ON/OFF switch is switched off,
the negative cable of the battery has been disconnected.
WARNING
Stirred up dirt particles and hazardous materials!
Injury to the eyes.
➤ Wear safety glasses.
NOTICE
Jet water can damage the machine!
Jet water can damage or destroy electrical components and sensitive display instruments.
➤ Do not direct jet water at electrical components.
➤ Observe the separate manufacturer instructions regarding external and internal cleaning
of the machine.
➤ Deploy the extension pole of the high-pressure washer in order to maintain the necessa‐
ry distance from the object being cleaned.
➤ Keep the extension pole of the high-pressure washer in constant motion.
➤ Clean the machine carefully!
8.4.1 Cleaning the exterior of the machine
Overview:
■ Open the closed floor pan (option)
■ Check the protective covers are over all plug sockets on the exterior of the machine (options)
■ Cover sensitive components
■ Clean the exterior
■ Remove the covers
8
Operation
8.4
Cleaning the machine after operation
No.: 9_9548 22 HCE
Operating Manual Portable Rotary Screw Compressor
MOBILAIR M27 PE
75
