1. Reconnect the negative cable to the battery.
2. Turn the «starter switch» to the “II” position and hold it there.
The fuel system is bled.
3. Turn the «starter switch» to the “0” position.
The venting process is completed.
4. Disconnect the negative cable on the battery.
10.3.3.2 Filter maintenance
Changing the fuel prefilter element:
The fuel filter element is a wear part and must be replaced at regular intervals, see maintenance
schedule, chapter 10.2.
Precondition The negative cable to the battery is disconnected!
Fig. 35 Fuel prefilter maintenance
1
Fuel line
2
Hose clamp
3
Fuel prefilter
1. Place the collecting vessel under the fuel prefilter.
2. Loosen the hose clamp of the fuel line on the filter cap.
3. Pull off the fuel line.
4. Catch fuel in the vessel.
5. Loosen and remove the fuel prefilter cap.
6. Remove the filter element.
7. Insert the new filter element.
8. Replace and fasten the fuel prefilter cap on the lower part.
9. Connect the fuel line to the cap.
10. Fasten the hose clamp of the fuel line.
11. Bleed the system as described previously.
Dispose of fuel and any materials and components contaminated with it in accordance with
environmental protection regulations.
Replacing the fuel filter cartridge of the fuel filter:
The fuel filter cartridge is a wear part and must be replaced at regular intervals, see maintenance
schedule, chapter 10.2.
10 Maintenance
10.3 Drive engine maintenance
110
Operating Manual Portable Rotary Screw Compressor
MOBILAIR M27 PE
No.: 9_9548 22 HCE
