C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
92
MAXPRO NVR 3.1 Operator’s Guide
4
Note:
For the streamers other than FishEye, the Enable Panorama options are not
visible.
•
Select the
Mounting Position
. The available options are
Wall
,
Ceiling
and
Ground
.
•
Select the
Modes
. The available options are
VCam
,
Panorama
,
Panorama Wide
,
and
Panorama Narrow
.
Note:
The
Mounting Position
and
Modes
are common to both the Halocam and
Evolution cameras.
5.
Click
Save
.
Image Stream Combinations for Oncam Grandeye Cameras
Each Halocam and Evolution camera works best when configured with a particular resolution
and fps. See
Appendix , Image Stream Combinations for Oncam Grandeye Cameras
section
for the optimum resolution and fps configurations for each of the cameras.
Viewing Live Video from Oncam Grandeye Cameras
See
Video Viewing Options from Oncam Grandeye Cameras
section.
Device Characteristics of Oncam Grandeye Cameras
See
Appendix , Device Characteristics of Oncam Grandeye Cameras
section.
Adding Axis 360/180 Camera
To add Axis 360/180 Camera in MAXPRO NVR
Note:
v3.1 SP1 or later supports discovering and adding Axis 360/180 models. These
were supported through RTSP only in v3.1 or lower versions.
1.
In MAXPRO NVR, click the
Configurator
tab. The
System
page displays by default.
2.
Click the
Camera
tab to open the
Camera
page.
3.
Under
Discover cameras here
•
Click
to discover the cameras in the network. By default, the check boxes
corresponding to all the discovered cameras are selected.
Summary of Contents for MAXPRO
