Honeywell MAXPRO, Operator'S Manual

Page: 109 / 256

. . . . .
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
MAXPRO NVR 3.1 Operator’s Guide 109
Figure 4-32 Server VMD Configuration
Note:
• You can draw a maximum of 10 ROIs (includes Include and Exclude
regions).
• Include regions are shown as green rectangles and Exclude regions are
shown in red rectangles in the field of view.
• Each region is assigned a unique identifier number for easy identification.
• The Exclude region overwrites the Include region. No motion is detected in
the area that is inside any of the exclusion regions.
6. Under Alarm Settings
• Type the Hold Time (sec) . This indicates the hold time for the motion video after the
detected motion stops. When motion is detected and motion video has started being
recorded, if motion stops briefly and then resumes within
Hold Time (sec) , no
“Motion stopped” event is generated. This brief gap in detected motion is ignored
and motion triggered recording continues without interruption. On the other hand, if
motion stops and no new motion is detected within
Hold Time (sec) , then the
“Motion stopped” event is reported. Motion triggered recording is then stopped after
additional Post-Alarm duration.
Note:
The Hold Time range is 0 to 30 seconds.
• The Object Size Threshold (the minimum object size required to trigger an alarm) is
displayed as a yellow rectangle in the field of view. Click and drag the corners of the
rectangle to resize the minimum object size for motion detection.