Honeywell MAXPRO, Operator'S Manual

Page: 33 / 256

. . . . .
M A X P R O N V R W I Z A R D
MAXPRO NVR 3.1 Operator’s Guide 33
2.
Step 2 - The CAMERA DISCOVERY page appears.
Figure 1-2 CAMERA DISCOVERY page
• All the settings that you have saved on the CONFIGURATION page are listed, along with
the discovered cameras. As each connected camera is discovered (notice the message
that displays on the lower right of your monitor) it is added to the list. This list disappears
as the cameras are added to the MAXPRO NVR software.
Figure 1-3 Discovered Cameras
Note:
The ADD button on the CAMERA DISCOVERY page appears only if you have
selected “ NO ” corresponding to Auto Add Discovered Camera in the
CONFIGURATION page. Use the ADD button to add discovered cameras of
your choice to the MAXPRO NVR software. Select the check boxes
corresponding to a camera from the discovered list, and click
ADD to add the
cameras.
• A MAXPRO NVR Wizard pop-up message appears detailing the available free channels
in the system on NVR Hybrid units if there are analog cameras (pre-configured or added
manually). It also gives you a hint about deleting the unused analog channels to add IP
cameras. Click
OK to continue.