Honeywell MAXPRO, Operator'S Manual

Page: 244 / 256

A P P E N D I X B
MAXPRO®NVRs - AXIS Camera/Encoders Discovery and Configuration (using ONVIF)
244 MAXPRO NVR 3.1 Operator’s Guide
B
MAXPRO®NVRs - AXIS Camera/Encoders
Discovery and Configuration (using ONVIF)
This section describes the steps to discover and configure the AXIS Camera/Encoders as an
ONVIF device in MAXPRO NVRs.
If you have questions concerning this document, please contact Honeywell Technical
Support. See the back cover for contact information.
Step 1: Enable ONVIF Web Service on AXIS
Camera/Encoder
Scenario Description
If you are unable to discover AXIS cameras/encoders using ONVIF compliance standard in
MAXPRO® NVR, ensure that ONVIF Web service is enabled and set up on the AXIS device.
The above scenario is noticed if you log on to the camera web page (for example to set the IP
address on the AXIS device) prior to discovering and configuring the device in NVR through
ONVIF; as a result the ONVIF Webservice gets disabled automatically.
Perform the steps in
Option 1: Add a ONVIF user in the camera web page. . or Option 2: Reset
to factory default settings to enable ONVIF on the AXIS devices.
Note:
AXIS P1347 Network Camera is used as an example to show the steps required.
Perform similar steps for other AXIS ONVIF devices.
Option 1: Add a ONVIF user in the camera web page.
To add a ONVIF User
1. Log on to the AXIS camera web page. The AXIS camera home page appears with live
video.