Holip HLP-A Series, Instruction Manual

Page: 64 / 117

HLP-A Series
HLP-A Series -
59
-
Explanation:
1. Stop after the program runs one cycle.
When the command of auto program operation is given, the inverter will
run with each set value of internal parameters. It will run for one cycle and
then stop automatically. The inverter will not restart and run until it receives
another command of operation.
2. Cycling run.
When the command of operation is given, the inverter will run in sequence
with the f requency of every speed step and running time set by each of
the internal parameters and will recycle. During the cycling run, except the
commands of stop, external faults and emergency stop, all other commands
will not be accepted.
3. Stop after it runs one cycle automatically (STOP for intervention)
Note:
①
When the command of auto program operation is given the inverter will
run with each parameters. But it will stop first and then restart at changing of
each step and will stop automatically after running for one cycle. The inverter
will not restart and run until it receives another command of operation.
②
The frequencies of each speed step are set by CD000 and CD080~CD086.
③
The running times of each speed step are set by CD087~CD094.
④
The running direction is set by CD078.
CD078 PLC Running Direction
Set Range: 0—255 Unit: 1 Factory Setting: 0
This parameter is only valid when CD076 is set to 4. This parameter setting
determine the running direction of each f requency of CD080~CD086 and
CD000 in the program operation. The setting method is as follows:
The rotation direction is set first in the binary 8 bits mode, and then converted
to a decimal value for the setting of this parameter. For instance: