Holip HLP-A Series, Instruction Manual

Page: 55 / 117

HLP-A Series
HLP-A Series
-
50
-
02: Fault Indication: The contact will act when the inverter detects abnormal
conditions.
03: Zero Speed: The contact will act when the output frequency of the inverter
is less than its starting frequency.
04: DC Braking indication: The contact will act when the inverter is in DC
braking.
05: Set Frequency reach: The contact will act when the output frequency of the
inverter reaches the set frequency.
06: Uniform Frequency 1 Reach: The contact will act when the output
frequency of the inverter reaches the designated frequency (CD061).
07: Uniform Frequency 2 reach: The contact will act when the output
frequency of the inverter reaches the designated frequency (CD062).
08: In Accel: The contact will act when the inverter is in ramp-up.
09: In Decel: The contact will act when the inverter is in ramp-down.
10: Inverter Over-load Alarm: The contact will act when the inverter detects
over-load.
11: Motor Overload Alarm: The contact will act when the inverter detects over-
load of the motor.
12: In Over-torque Detect: The contact will act when the inverter detects over-
torque.
13: Low Voltage Alarm: The contact will act when the inverter detects low
voltage.
14: Single Step End: The contact will act and generate one pulse when the
inverter finishes a single step in implementation of program operation.
15: Process End: The contact will act and generate one pulse when the inverter
f inishes all the steps (i.e. af ter one cycle) in implementation of program
operation.
16: Set Counter Reach: The contact will act when the inverter implements the
external counter and the counting value is equal to the set value (CD064).
17: Middle Counter Reach: The contact will act when the inverter implements
the external counter and the counting value is greater than or equal to the
set value (CD075).
18: External Control Timer 1 reach: The contact will act when the timer reaches
the set value.
19: External Control Timer 2 reach:
20: 4~20mA disconnected: When AI input signal is opened the contact will act.
21~24: Reserved.
25: Auxiliary Pump 1: This contact controls the starting and stopping of
auxiliary pumps. For details refer to Operation of Multi-pumps.
26: Auxiliary Pump 2
27: Drawing reach: The contact will act when the drawing action is finished.
The contact will automatically reset when the inverter stops.