Holip HLP-A Series, Instruction Manual

Page: 112 / 117

HLP-A Series
HLP-A Series -
107
-
for confirmation. When 0 (i.e. content of CD033) is displayed, press Δ to change
the value to “1” and press Key “SET” for confirmation. It will display END
and later CD034. Other parameters can be set in the same way. After finishing
setting, find PROG Key and return to the main menu to show the value for
frequency.
⑷
Other parameters setting:
CD033 : 1 < External terminal control >
CD034 : 1< External potentiometer control>
CD050 : 1< FOR terminal is set to RUN, Close RUN, Open STOP>
Finally CD010=1 , < Parameter Lock, i.e. lock the parameters. When it needs to
be reset, first set CD010 to 0, i.e. unlock>
⑸
Run operation
①
When the external switch K1 is closed it runs;
②
Adjust the knob of potentiometer for tuning the speed;
③
When the job is finished adjust the knob of potentiometer to zero;
④
Press K1<Open >, the inverter stops;
⑤
Power off.
⑹
Attentions:
①
Both the power line and motor line must be correctly connected.
②
During operating the power must be disconnected after the inverter stops.