25 / 160
EN
PL
HU
SK
DE
CS
Also, tilling soil that is too wet will produce unsatisfactory clods. Wait a day or two after heavy
rain for the soil to dry.
WARNING! Do not use the machine in a case of heavy, wet clay soil. It can cause
permanent damage to the machine.
Better growth will be obtained if an area is tilled properly and used soon after tilling to preserve
the moisture content. The type of soil and working conditions will determine the actual setting of
the tilling depth. In some soils, the desired depth is reached irst pass over garden. In other soils,
the desired depth is obtained by going over the garden two or three times. In later case, the depth
regulator rod should be lowered before each succeeding pass over the garden. Passes should be
made across the length and width of the garden alternately. Do not try to dig too deeply in the irst
pass. If the machine jumps or bucks, allow the unit to move forward at a lightly faster rate. If the
tiller stops forward motion and tries to dig in one spot, rock the handles from side to side to start
it moving forward again. Rocks which are turned up should be removed from the garden area.
WARNING: if you strike a foreign object, stop the engine. Disconnect wire from spark
plug, thoroughly inspect the machine for any damage and repair the damage before
restarting and operating the machine. Extensive vibration of the machine during
operation is an indication of damage (especially blade and shaft). The machine
should be promptly inspected and repaired. Contact an authorized service center.
MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free operation.
WARNING! Improper maintenance, or failure to correct a problem before operation,
can cause malfunction in which you can be seriously hurt or killed. Always
follow the inspection and maintenance recommendations and schedules in this
owner’s manual.
Disconnect the spark plug before performing any service on the machine. Wait till
all moving parts are completely stopped.
• To help you properly care for your engine, the following pages include a maintenance schedule,
routine inspection procedures, and simple maintenance procedures using basic hand tools.
Other service tasks that are more difficult, or require special tools, must be performed by an
authorized service centre.
• The maintenance schedule applies to normal operating conditions. If you operate your engine
under severe conditions, such as sustained high-load or high-temperature operation, or use in
unusual wet or dusty conditions, consult your servicing dealer for recommendations applicable
to your individual needs and use.
• After finishing season carefully clean the machine and all metal and moving parts lubricate by
grease or oil so that the machine would be prepared for next season. Before next operation
with the machine carefully check all the components.
• Frequently check fastening of all screws, nuts etc. in order to keep the machine in safe working condition.
• Once in the season let inspect and maintain the machine in authorised service center.
WARNING! Failure to properly follow maintenance instructions and precautions
can cause you to be seriously hurt or killed. Always follow the procedures and
precautions in this owner‘s manual.
