1/3/05
888-2517-001
2-23
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation & Setup
eCDi ™
2.5.1
Setting APEX IP Address
If one or more APEX exciters are to be connected to the eCDi™ , it is necessary to set
an IP Address and Subnet Mask for each exciter. Go to the display on the front of the
APEX exciter and select Home - Setup - Serial I/O. This will bring up the screen in
Figure 2-15A. Select NEXT to open the Ethernet Setup screen shown in Figure 2-15B.
Click on each number to bring up the edit window and change them one at a time to that
shown here.
The exciter will have to be shut off and then turned back on before the
changes will take effect.
The following IP addresses were implemented as of eCDi™ software revision 2.6.K or
higher. For all previous versions see the NOTE below.
•
IP Address: 192.168.217.200
•
Subnet Mask: 255.255.255.0
Set the second exciter to:
•
IP Address: 192.168.217.201
•
Subnet Mask: 255.255.255.0
Figure 2-15 APEX Exciter Ethernet Setup Screen
NOTE:
For all eCDi™ software revisions
before 2.6.K use the following IP
addresses for the APEX exciter:
Exciter 1: 192.168.0.200
Exciter 2: 192.168.0.201
Select Next
(A)
(B)
NOTE:
The exciter will have to be shut off (ac
power removed) and then turned back
on before the changes will take effect.
Summary of Contents for eCDi
Page 4: ...MRH 2 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 6: ...vi 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 8: ...viii 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 12: ...xii 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
