1/3/05
888-2517-001
2-31
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation & Setup
eCDi ™
Figure 2-22 General Configuration Screen
STEP 6
Set a new administrator password. Although shown checked here, the
“Allow remote administration” checkbox should only be checked if you
want to be able to access these configuration screens via the station LAN
or WAN. If this box is not checked, then only a local connection to the
front of the eCDi™ unit will allow access to the configuration screens.
STEP 7
Set the Location of the box and/or any call letters. This is used by the
browser applet, email and SNMP.
STEP 8
Set the correct time and date. This information is used for time stamping
of the metering and fault logs. Use the pull down menu to select the
appropriate time zone.
STEP 9
Time Server IP (recommended): If there is a time server available on the
local network it will be auto-detected or can be set manually. An internet
time server could also be used. If no time server is specified, the internal
pc clock will be used and will require manual setting at frequent
intervals for accurate time stamping of logs.
NOTE:
Time Zone setting will affect the time even when a Time Server is used.
STEP 10
When all changes are made, press Submit and then press Back to return
to the main menu.
Summary of Contents for eCDi
Page 4: ...MRH 2 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 6: ...vi 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 8: ...viii 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 12: ...xii 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
