Harris eCDi, Technical Manual

Page: 60 / 190

2-38 888-2517-001 1/3/05
WARNING: Disconnect primary power prior to servicing.
eCDi ™
Section 2 Installation & Setup
Figure 2-29 Email Filters
•
Selecting “ None ” (no filter) will allow all indications for the selected
category to send an email alert.
•
Selecting “ Sum ” will block all Summary indications in the selected
category. All other indications in that category will send an email alert.
•
Selecting “ All but Sum ” (the most common selection) will block all
emails but the Summary indications for the selected category (i.e. only
summary indications will send an alert email).
•
Selecting “ All ” will block all emails for that category. This is most
commonly used for the Info category since these are mostly Status
indications.
NOTE:
Checking the “Local Mode” checkbox will disable all email alerts when the
transmitter is in Local mode (or Remote Disable as the case may be).
STEP 31
When all changes are made, press Submit and then press Back to return
to the main menu. Click on Applet to access the screen in Figure 2-30.
IMPORTANT:
When “Apply” is pressed on the Configuration main menu (shown in Figure 2-
21), the eCDi™ will send a test email to all of the addresses in the list. It will also
send SNMP Trap messages to all specified SNMP Network Managers.