1/3/05
888-2517-001
A-1
WARNING: Disconnect primary power prior to servicing.
eCDi ™
Appendix A
SigmaCD Fault and
Meter Log Reference
A.1
Introduction
For the SigmaCD transmitter, all data in the transmitter is either displayed via the GUI,
lights an LED or is sent to the parallel remote control ports. Some of the fault reporting
is done in the form of highlighting a button red, such as most summary faults, but this
fault will not usually show in a fault log on the transmitter GUI. However, when the
data is sent out a serial port to a device such as the eCDi™ the only way to represent a
fault is through a name. The same issue applies to Metering data. Therefore, this section
is divided into 2 parts:
•
Fault Log Reference
•
Metering Log Reference
The Fault Log Reference is a group of tables that list all of the faults that can be
reported and logged on the eCDi™ for a SigmaCD transmitter. The faults are divided
into 5 tables by category:
•
Table A-1, “System Fault Reference,” on page A-2
•
Table A-2, “Power Supply Fault Reference,” on page A-3
•
Table A-3, “Power Amplifier Fault Reference,” on page A-3
•
Table A-4, “Output Fault Reference,” on page A-4
•
Table A-5, “SigmaCD Diamond Drive IPA Faults,” on page A-5
•
Table A-6, “SigmaCD Bipolar IPA Faults,” on page A-7
The Metering Log Reference is a group of tables that list all of the Meter readings that
can be logged on the eCDi™ for a SigmaCD transmitter. The meters are divided into 3
tables by category:
•
Table A-7, “SigmaCD System Meters,” on page A-8
•
Table A-8, “SigmaCD Diamond Drive IPA Meters,” on page A-9
•
Table A-9, “SigmaCD Bipolar IPA Meters,” on page A-10
Summary of Contents for eCDi
Page 4: ...MRH 2 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 6: ...vi 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 8: ...viii 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
Page 12: ...xii 888 2517 001 1 3 05 WARNING Disconnect primary power prior to servicing...
