Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches
Chapter 3 OSPF Configuration
3-22
Task
Remarks
Configuring OSPF Route Summarization
Optional
Configuring OSPF Inbound Route Filtering
Optional
Configuring ABR Type-3 LSA Filtering
Optional
Configuring an OSPF Cost for an Interface
Optional
Configuring the Maximum Number of OSPF Routes
Optional
Configuring the Maximum Number of Load-balanced
Routes
Optional
Configuring a Priority for OSPF
Optional
Configuring
OSPF Route
Control
Configuring OSPF Route Redistribution
Optional
Configuring OSPF Packet Timers
Optional
Specifying an LSA Transmission Delay
Optional
Specifying SPF Calculation Interval
Optional
Specifying the LSA Minimum Repeat Arrival Interval
Optional
Specifying the LSA Generation Interval
Optional
Disabling Interfaces from Sending OSPF Packets
Optional
Optional
Configuring OSPF Authentication
Optional
Adding the Interface MTU into DD Packets
Optional
Configuring the Maximum Number of External LSAs
in LSDB
Optional
Making External Route Selection Rules Defined in
RFC1583 Compatible
Optional
Logging Neighbor State Changes
Optional
Configuring OSPF Network Management
Optional
Configuring
OSPF Network
Optimization
Enabling the Advertisement and Reception of
Opaque LSAs
Optional
Configuring the OSPF GR Capability
Optional
Configuring the OSPF GR Helper
Optional
Configuring
OSPF
Graceful
Restart
Triggering OSPF Graceful Restart
Optional
3.3 Configuring OSPF Basic Functions
You need to enable OSPF, specify an interface and area ID first before performing other
tasks.