Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
Chapter 8 Multicast Routing and Forwarding
Configuration
8-8
Follow these steps to configure a multicast static route:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Configure a
multicast static route
ip rpf-route-static source-address
{
mask
|
mask-length
} [
protocol
[
process-id
] ]
[
route-policy
policy-name
]
{
rpf-nbr-address
|
interface-type
interface-number
} [
preference
preference
] [
order
order-number
]
Required
No multicast
static route
configured by
default.
Caution:
When configuring a multicast static route, you cannot designate an RPF neighbor by
specifying an interface (by means of the
interface-type interface-number
command
argument combination) if the interface type of that router is Loopback or
VLAN-interface; instead, you can designate an RPF neighbor only by specifying an
address (
rpf-nbr-address
).
8.3.4 Configuring a Multicast Route Match Rule
If more than one route exists to the same subnet, a router chooses a route based on the
sequence of route configuration.
Follow these steps to configure a multicast route match rule:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Configure the device to
select a route based on
the longest match
multicast longest-match
Required
In order of routing table
entries by default
8.3.5 Configuring Multicast Load Splitting
With the load splitting feature enabled, multicast traffic will be evenly distributed among
different routes.