Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
Chapter 3 Tunneling Configuration
3-16
3.5.2 Configuration Procedure
Follow these steps to configure a 6to4 tunnel:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable IPv6
ipv6
Required
By default, the IPv6
packet forwarding
function is disabled.
Create a tunnel interface and
enter tunnel interface view
interface tunnel
number
Required
By default, there is
no tunnel interface
on the device.
ipv6 address
{
ipv6-address
prefix-length
|
ipv6-address/prefix-length
}
Configure an
IPv6 global
unicast
address or
site-local
address
ipv6 address
ipv6-address/prefix-length
eui-64
Required.
Use either
command.
By default, no IPv6
global unicast
address or site-local
address is
configured for the
tunnel interface.
ipv6 address auto
link-local
Configure an
IPv6 address
for the tunnel
interface
Configure an
IPv6 link-local
address
ipv6 address
ipv6-address
link-local
Optional
By default, a
link-local address
will automatically be
generated when an
IPv6 global unicast
address or site-local
address is
configured.
Set a 6to4 tunnel
tunnel-protocol
ipv6-ipv4 6to4
Required
By default, the
tunnel mode is
manual. The same
tunnel type should
be configured at
both ends of the
tunnel. Otherwise,
packet delivery will
fail.
Configure a source address or
interface for the tunnel
source
{
ip-address
|
interface-type
interface-number
}
Required
By default, no
source address or
interface is
configured for the
tunnel.
