Operation Manual – File System Management
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 File System Management Configuration
1-8
Follow the step below to save the current configuration:
To do…
Use the command…
Remarks
Save the current
configuration
save
[
file-name
|
safely
]
Required
Available in any view
Note:
z
Fast saving mode is suitable for environments where power supply is stable. The
safe mode, however, is preferred where stable power supply is unavailable or
remote maintenance is involved.
z
The extension name of the configuration file must be .cfg.
z
If you press <Enter> after entering the
save
command, you can save the
configuration file in an interactive way. In this way, you can use the default path or
enter a filename to specify a new path, but the suffix of the filename must be “.cfg”
and the path must be the path of the storage device on the AMB (active main board).
1.2.3 Erasing the Startup Configuration File
With the configuration file erased, your device will boot up with the default configuration
next time it is powered on.
You may need to erase the configuration file for one of these reasons:
z
After you upgrade software, the original configuration file does not match the new
software.
z
The startup configuration file is corrupted or not the one you need.
Follow the step below to erase the configuration file:
To do…
Use the command…
Remarks
Erase the startup
configuration file from the
storage device
reset
saved-configuration
Required
Available in user view
Caution:
This command will permanently delete the configuration file from the device. Use it with
caution.