Operation Manual – Link Aggregation
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 Link Aggregation Configuration
2-2
addresses or black hole MAC addresses configured, voice VLAN-enabled ports,
or 802.1x-enabled ports.
z
After you remove a manual aggregation group, all the ports in the group are
dismissed from it.
z
For a manual aggregation group containing only one port, the only way to remove
the port from it is to remove the aggregation group.
z
To make an aggregation group function properly, make sure that the
selected/unselected state of the ports at both ends of a link is consistent.
2.1.2 Configuring a Static LACP Link Aggregation Group
Follow these steps to configure a static aggregation group:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Configure the system
LACP priority
lacp
system-priority
system-priority
Optional
32768 by default.
Changing system LACP
priority can affect the
selected/unselected state
of the ports in the group.
Create a static LACP
aggregation group
link-aggregation group
agg-id
mode
static
Required
Enter Ethernet port view
interface interface-type
interface-number
––
Configure the port LACP
priority
lacp
port
-
priority
port-priority
Optional
32768 by default.
Changing port LACP
priority can affect the
selected/unselected state
of the ports in the group.
Assign the Ethernet port
to the aggregation group
port link-aggregation
group agg-id
Required
Note that:
z
You can create a static aggregation group by changing the type of an existing
manual link aggregation group that contains no port.
z
An aggregation group cannot contain the following ports: RRPP-enabled ports,
reflector ports or destination ports of port mirroring groups, ports configured with
static MAC addresses or black hole MAC addresses, voice VLAN-enabled ports,
or 802.1x-enabled ports.
z
After you remove a static aggregation group, all the ports in the group are
dismissed from it, and LACP is disabled on the ports.
