Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 NQA Configuration
1-29
To do…
Use the command…
Remarks
Configure the source IP
address of a test request
packet
source-ip
ipaddress
This command is required
for the FTP test but optional
for other tests.
You can specify an IP
address as the source IP
address of a test request
packet. Otherwise, the IP
address of the interface
sending packets serves as
the source IP address of the
test request packet.
The source IP address in the
command must be the IP
address of an interface on
the device and the interface
must be up. Otherwise, the
test will fail.
This command is invalid for
the DHCP test.
Configure the source port
of a test request packet
source-port
port-number
Optional
You can specify a port as the
source port of a test request
packet. Otherwise, the
system automatically
assigns a port to serve as
the source port of the test
request packet.
This command is only valid
for jitter, UDP, and SNMP
tests.
Enable the routing table
bypass function
sendpacket passroute
Optional
Disabled by default. If you
want to test the connectivity
between the local address
and the destination address,
you can enable this function.
After this function is enabled,
the routing table will not be
searched, and the packet is
directly sent to the
destination in the directly
connected network. If the
destination is not in the
directly connected network,
an error will be prompted.
This command is invalid for
the DHCP test.