Operation Manual – VRRP
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 VRRP Configuration
1-35
# Display detailed information of standby group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 500
Admin Status : UP State : Backup
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 5
Auth Type : SIMPLE TEXT Key : hello
Virtual IP : FE80::10
Master IP : FE80::1
The above information indicates that in standby group 1 Switch A is the master, Switch
B is the backup and packets sent from Host A to Host B are forwarded by Switch A.
If Switch A is in work, but its interface VLAN-interface 3 is not available, you can still
ping through Host B on Host A. You can use the
display vrrp ipv6
command to view
the detailed information of the standby group.
# If Switch A is in work, but its interface VLAN-interface 3 is not available, the detailed
information of standby group 1 on Switch A is displayed.
[SwitchA-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 500
Admin Status : UP State : Backup
Config Pri : 110 Run Pri : 80
Preempt Mode : YES Delay Time : 5
Auth Type : SIMPLE TEXT Key : hello
Track IF : Vlan-interface3 Pri Reduced : 30
Virtual IP : FE80::10
Master IP : FE80::2
# If Switch A is in work, but its interface VLAN-interface 3 is not available, the detailed
information of standby group 1 on Switch B is displayed.
[SwitchB-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 500
