Operation Manual – VRRP
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 VRRP Configuration
1-29
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Virtual IP : 202.38.160.111
Master IP : 202.38.160.1
Interface : Vlan-interface2
VRID : 2 Adver. Timer : 1
Admin Status : UP State : Master
Config Pri : 110 Run Pri : 110
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Virtual IP : 202.38.160.112
Virtual MAC : 0000-5e00-0102
Master IP : 202.38.160.2
The above information indicates that in standby group 1 Switch A is the master, Switch
B is the backup and the host with the default gateway of 202.38.160.111/24 accesses
the Internet through Switch A; in standby group 2 Switch A is the backup, Switch B is
the master and the host with the default gateway of 202.38.160.112/24 accesses the
Internet through Switch B.
1.5 IPv6-Based VRRP Configuration Examples
This section provides these configuration examples:
z
Single VRRP Standby Group Configuration Example
z
VRRP Interface Tracking Configuration Example
z
Multiple VRRP Standby Group Configuration Example
1.5.1 Single VRRP Standby Group Configuration Example
I. Network requirements
z
Host A needs to access Host B on the Internet, using FE80::10 as its default
gateway.
z
Switch A and Switch B belong to standby group 1 with the virtual IP address of
FE80::10.
z
If Switch A operates normally, packets sent from Host A to Host B are forwarded
by Switch A; if Switch A fails, packets sent from Host A to Host B are forwarded by
Switch B.