Operation Manual – System Maintaining and Debugging
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 Basic Configurations
1-10
Caution:
z
When you configure the password for switching user level with the
super password
command, the user level is defaulted to 3 if no user level is specified.
z
You can switch to a lower user level unconditionally. To switch to a higher user level,
however, you need to enter the password needed (The password can be set with
the
super password
command.). If the entered password is incorrect or no
password is configured, the switch fails. Therefore, before switching to a higher user
level, you should configure the password needed.
z
You are recommended to use the default user level; otherwise the change of user
level may bring inconvenience to your maintenance and operation.
1.1.7 Displaying and Maintaining Basic Configurations
To do…
Use the command…
Remarks
Display information on
system version
display version
Display information on the
system clock
display clock
Display information on
terminal users
display users
[
all
]
—
Display the configurations
saved in the storage
device
display saved-configuration
[
by-linenum
]
Display the current
validated configurations
display current-configuration
[ [
configuration
[
configuration
] |
controller
|
interface
[
interface-type
]
[
interface-number
] ] [
by-linenum
] [
|
{
begin
|
include
|
exclude
}
text
] ]
—
Display the valid
configuration under
current view
display this
[
by-linenum
]
Display clipboard
information
display
clipboard
—
Display and save
statistics of each module’s
running status
display diagnostic-information
—
During daily maintenance or when the system is operating abnormally, you need to
view each module’s running status to find the problem. Therefore, you are required to
execute the corresponding
display
commands one by one. To collect more information
