GE C60, Instruction Manual

Page: 157 / 682

GE Multilin C60 Breaker Protection System 5-21
5 SETTINGS 5.2 PRODUCT SETUP
5
Example: If this setting is "Yes" and an attempt is made to change settings or upgrade the firmware, the UR device denies
the setting changes and denies upgrading the firmware. If this setting is "No", the UR device accepts setting changes and
firmware upgrade.
This role is disabled by default.
FACTORY SERVICE MODE: When enabled (meaning "Yes" is selected) the device can go into factory service mode. For
this setting to become enabled a Supervisor authentication is necessary. The default value is Disabled.
SUPERVISOR ROLE: When enabled (meaning "Yes" is selected) the Supervisor role is active. When "No" is selected this
role is disabled. To disabled this setting a Supervisor authentication is necessary. If disabled, the Supervisor role is not
allowed to log on. In this case the Administrator can change the settings under the Supervisory
menu.
If enabled, Supervisor authentication is required to change the settings in the Supervisory menu. If the Supervisor disables
his role after authentication, the Supervisor session remains valid until he switches to another role using MMI or until he
ends the current Supervisor session if using communications.
This role is disabled by default.
SERIAL INACTIVITY TIMEOUT : The role logged via a serial port is auto logged off after the Serial Inactivity timer times
out. A separate timer is maintained for RS232 and RS485 connections. The default value is 1 minute.
a) SELF TESTS
PATH: SETTINGS

PRODUCT SETUP

SECURITY

SUPERVISORY

SELF TESTS
FAILED AUTHENTICATE — When Enabled, the number of failed authentications is compared with the Session Lockout
threshold. When the Session Lockout threshold is exceeded, a minor alarm indication comes up. Operand is
AUTHENTICA-
TION FAIL
.
FIRMWARE LOCK — When Enabled, any firmware upgrade attempt brings up a minor self-test alarm. Operand is
UNAUTH
FW ATTEMPT
.
SETTINGS LOCK — When Enabled, an unauthorized write attempt to a setting for a given role activates a minor self test
alarm. Operand is
UNAUTH SETTING WRITE
.
PATH: SETTINGS

PRODUCT SETUP

SECURITY

SUPERVISORY

SELF TESTS

FAILED AUTHENTICATE
CYBERSENTRY SETUP
When first using CyberSentry security, use the following procedure for set up.
1. Log in to the relay as Administrator by using the Value keys on the front panel to enter the default password
"ChangeMe1#". Note that the "Lock relay" setting needs to be disabled in the
Security > Supervisory menu. When
this setting is disabled, configuration and firmware upgrade are possible. By default, this setting is disabled.
2. Enable the Supervisor role if you have a need for it.
3. Make any required changes in configuration, such as setting a valid IP address for communication over Ethernet.
4. Log out of the Administrator account by choosing None.
Next, device or server authentication can be chosen on the login screen, but the choice is available only in EnerVista. Use
device authentication to log in using the five pre-configured roles (Administrator, Supervisor, Engineer, Operator,
Observer). When using a serial connection, only device authentication is supported. When server authentication is
required, characteristics for communication with a RADIUS server must be configured. This is possible only in the EnerV-

SELF TESTS


FAILED

AUTHENTICATE
See below
MESSAGE
FIRMWARE LOCK:
Enabled
Range: Enabled, Disabled
MESSAGE
SETTINGS LOCK:
Enabled
Range: Enabled, Disabled

FAILED

AUTHENTICATE
FAILED AUTHENTICATE:
Enabled
Range: Enabled, Disabled