1
Wirefree Remote Controller SR801-2
Installation and Operating Instructions
These instructions should be read in conjunction
with your System Installation and Operating
Manual and be retained for future reference
A LED indicator
E Panic Switch
B Arm
F Key Chain Ring
C
Part-Arm
G Negative Polarity
D
Disarm
H Positive Polarity
The Remote Controller is used to Arm, Part-Arm and
Disarm the system. It is compatible with a series of our
control panels, such as SC801 (2 zones), SC811 (8
zones), SC821 (12 zones) and SE801 (solar-powered
siren & strobe), operating at 868MHz or 923MHz only.
The Remote Controller also incorporates a Panic
switch. Activating the Panic switch will immediately
initiate a Full Alarm condition whether the system is
Armed or Disarmed, (unless the system is in Test
mode).
The Remote Controller adopts a CR2032 type Lithium
cell which under normal conditions will have typical life
in excess of 1 year. Under normal battery conditions
the LED on the Remote controller will only illuminate
when a button is pressed. However, under low
battery conditions the orange LED will illuminate every
time the button is pressed. When this occurs the
batteries should be replaced as soon as possible.
SETTING THE REMOTE CONTROLLER
1. Remove the rear cover with a coin.
2. Insert the battery ensuring that the +v terminal
faces upwards away from the PCB.
3. Replace the rear cover.
LEARNING THE ID CODE
In order to communicate with the Control Panel, the ID
code of the Remote Controller and Control Panel need
to be learnt with each other. By pressing the
button
will emit the ID code to the Control Panel instantly,
subject to the Control Panel being set at the ID code
learning mode.
To emit the ID code to the control panel, proceed the
following steps in sequence:
1. Press the
button for more than 3 seconds until
the green LED of the Remote Controller flashes. It
implies that the Remote Controller enters ID code
learning mode.
2. A 30-second countdown will start. If the ID code
has been learnt within 30 seconds by the control
panel successfully, the LED of the Remote
Controller will be on before exit the learning mode.
If failure, the LED of the Remote Controller will
flash three times rapidly before exit the learning
mode.
Note:
The Remote Controller owns only one ID
code to be learnt by the control panel.
LED INDICATION
Function LED
Indication
RF transmission
Green LED illuminating for one
second
Failed RF transmission
Red LED illuminating for one
second
Low
battery
Orange LED illuminating for
one second
Success in learning the ID
code
Green LED illuminating for 0.5
second
If the control panels have
been activated,
Green LED flashing for 3
seconds
