3
SPECIFICATIONS
Battery Type
CR2032 3V/230mAhr
Operating Frequency
868MHz or 923MHz
*Specifications are subject to change without prior notice.
A501110742R01
Warning:
Do not dispose of electrical appliances as unsorted
municipal waste, use separate collection facilities.
Contact your local government for information
regarding the collection systems available.
If electrical appliances are disposed of in landfills or
dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging
your health and well-being.
When replacing old appliances with new once, the
retailer is legally obligated to take back your old
appliance for disposal at least for free of charge.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE
STATEMENT
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures: – Reorient or
relocate the receiving antenna. – Increase the
separation between the equipment and receiver. –
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. –
Consult the dealer or an experienced radio/TV
technician for help.
CAUTION:
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference and (2)
This device must accept any interference received,
including interference that may cause undesired
operation.
Information for the OEMs and Integrators The following
statement must be included with all versions of this
document supplied to an OEM or integrator, but should
not be distributed to the end user. This device is
intended for OEM integrators only. Please See the full
Grant of Equipment document for other restrictions.
Label Information to the End User by the OEM or
Integrator The following regulatory and safety notices,
the final end product must be labeled with "Contains
FCC ID: FU5SR801-2 in a visible area.
