163
This function is used to adjust the pitch and
the throttle rise characteristic at acceleration/
deceleration operation. An acceleration function
which temporarily increases the pitch and throttle
operations at throttle stick acceleration/deceleration
operation can be set.
Example of acceleration function use
●When used at pitch, the acceleration
function is effective when you want to
quicken the response of the fuselage at 3D
flight flip, etc.
When used, high pitch temporarily exceeds
maximum pitch, but immediately returns to
maximum pitch.
Setting method
● Acceleration can be set at both setting
at acceleration (high) and setting at
deceleration (low).
(The operation point is displayed on a
graph.)
● Acceleration rate setting (Rate)
● The return time after operation (Damping)
can be set.
Acceleration
● Select [Acceleration] at the model
menu and call the setup screen shown
below.
Operation up to this
range will initiate
acceleration.
Act position
The rate the angle
increases.
To next page
1/2 : Pitch
2/2 : Throttle
The return time after operation (Damping)
can be set.
（First return）1 ～ 100（Slow return）
（Acceleration doesn't function as 0.）
W h e n u s i n g t h i s
function, Tap [INH].
(ON is displayed.)
Condition group/
single mode selection
(Gr. /Sngl)
Current position
● The operation point at acceleration
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
Note: When using the acceleration function,
since the pitch stroke is large, make your
settings so there is no binding of your linkage.
●Return to Model menu
Summary of Contents for 01000141
Page 1: ...1M23Z07702 WEB FULL MANUAL ...
Page 225: ......
