Furuno FAR-1416, Operator'S Manual

Page: 69 / 226

1. OPERATIONAL OVERVIEW
1-55
1.38.5 How to reset the PI lines to default (ship’s heading)
You can automatically return PI lines to default orientation (ship’s heading), 0-degrees
for parallel orientation, 90-degrees for perpendicular orientation. This is faster than do-
ing it manually.
From the PI line box
Place the cursor inside the PI line box, then press and hold the left button .
From the menu
1. Open the [MAIN MENU].
2. Select [CURSOR/OWN SHIP MARK], then press the
left button .
3. Select [PI LINE], then press the left button .
4. Select [PI LINE RESET], then press the left button .
5. Close the menu.
1.39 How to Use the Net Cursor (Diamond Cursor)
The net cursor is used to depict your fishing net on the ra-
dar display. It is especially useful for bottom trawlers for
knowing where the net is located. Enter the dimensions of
your net in the menu to show the net in scale on the dis-
play.
1.39.1 How to activate the net cursor
To activate the net cursor, do the following procedure.
1. Open the [MAIN MENU].
2. Select [CURSOR/OWN SHIP MARK], then press the
left button .
3. Select [NET CURSOR], then press the left button .
4. Select [NET CURSOR DISPLAY], then press the left
button .
5. Select [ON], then press the left button .
The net cursor appears on own ship’s mark.
6. Close the menu.
1.39.2 How to set the net cursor dimensions and orientation
1. Open the [MAIN MENU].
2. Select [CURSOR/OWN SHIP MARK], then press the
left button .
3. Select [NET CURSOR], then press the left button .
EBL2
Net cursor
(Dimond cursor) Net cursor
(Dimond cursor)
[NET CURSOR]
1. BACK
2. NET CURSOR DISPLAY
OFF/ON
3. FRONT HALF LENGTH
0.0m
4. REAR HALF LENGTH
0.0m
5. NET WIDTH
0.0m
6. ROTATE STEP
360°/ 32 POINTS
WARP LENGTH
0.0m