Furuno FAR-1416, Operator'S Manual

Page: 151 / 226

5. VIDEO PLOTTER OPERATION
5-35
3. Press the WPT key to register a turn point as a waypoint.
The same message as above appears.
How to stop the route creation
To stop the course creation, do the following procedure. When the route points reach
100 points, the route creation will be stop automatically.
1. Open the [MAIN MENU].
2. Select [ROUTES/WAYPOINTS], then press the
left button .
3. Select [ROUTES LIST], then press the left button .
4. Select [BACK TRACK], then press the left button .
5. Select [NO], then press the left button .
6. Press the right button to close the menu.
How to register the specified track as a route
1. Open the [MAIN MENU].
2. Select the [TRACK], then press the
left button .
3. Select [TRACK ROUTE CONVERSION], then press the left button .
The [TRACK ROUTE CONVERSION] window appears. Waypoints on converted
routes are shown as small squares.
4. Select the square waypoint to use as the route start point, then press the left but-
ton .
5. Select the end waypoint in a similer manner, then press the left button .
6. Select [DIST.] on [FILTER SET], then press the left button .
7. Rotate the scrollwheel to set filter.
8. Select [BEARING] on [FILTER SET], then press the left button .
9. Select [CONVERSION], then press the left button .
The number of track points to be used in the route as waypoints appears.
PRESS CURSOR AT START OF TRACK CONVERSION.
PRESS LEFT BUTTON TO CONFIRM
TRACK ROUTE CONVERSION
SEL METH. : BTWN 2PTS
FILTER SET
NO. OF DST TO CONV :0/100
[WPT]: CONVERTS TRACK POINT TO WAYPOINT.
[DELETE]: CANCEL CONVERTION PRESS RIGHT BUTTON: GO BACK.
PRESS LEFT BUTTON TO CONFIRM
TRACK ROUTE CONVERSION
SEL METH. : BTWN 2PTS
FILTER SET
NO. OF DST TO CONV :3/100