Furuno FAR-1416, Operator'S Manual

Page: 36 / 226

1. OPERATIONAL OVERVIEW
1-22
How to change the navigation data
1. Press the CURSOR ON/OFF key, if the cursor is not shown.
2. Move the cursor onto the information box desired.
3. Press the
left button several times to select the information.
You can also select the information by pressing the left button , then rotate the
scrollwheel .
How to hide the navigation data box
1. Open the [MAIN MENU].
2. Select [NAV DATA], then press the
left button .
3. Select [DATA BOX 1] (or DATA BOX 2/3), then press the left button .
4. Select [OFF], then press the left button .
5. Close the menu.
1.17 How to use MOB Mark
When a person falls overboard from the vessel, use the MOB (Man Overboard) func-
tion. This mark shows the range, bearing and estimated time to MOB position.
Note: Following operations are enable when [ROUTE SELECT] is set to [IN] in the
[ROUTE/WAYPOINT] menu.
Enter the MOB mark
1. Press the CURSOR ON/OFF key, if the cursor is not shown.
2. Move the cursor onto the MOB box at the bottom-right of the screen.
3. Press the
left button .
The MOB mark ( ) is entered on the location of own ship’s position and the con-
firmation message box appears.
4. Select [RUN], then press the left button .
The line between MOB location and own ship appears. The information box for
waypoint at the top of the screen indicates the time to go to the waypoint.
Note: Only one MOB mark can be entered any one time. When a new MOB mark
is entered, the old mark is deleted.
Erase the MOB mark
1. Press the CURSOR ON/OFF key, if the cursor is not shown.
2. Move the cursor onto the MOB box at bottom-right on the screen.
MOB POSITION SAVED. GOTO MOB?
(CURRNT WAYPOINT WILL BE
CANSELLED)
RUN CANCEL
MOB
176.0° R
0.517
NM
MOB BOX
SPEED
3.4
kn
2017/01/01 01:30
34°15.0000N
135°15.0000E
GAI
SEA
RAI
TTG 00:00 110.0°R 0.000NM
NM
HEADING
250.0
° T
Target information box