FHF ExResistTel IP2/IP154, Operating Instructions Manual

Page: 309 / 412

Manual ResistTel IP2 / IP152 Page 309
ExResistTel IP2 / IP154
4.9.3.1.5 Maintenance Commands
Additional commands implemented specially for the update server are available. The
maintenance file is executed every time (depending on the interval set), as soon as it
is received.
4.9.3.1.6 Check Command
In most cases, however, the maintenance file should be executed not every time as
soon as it is received, but once only. Assuming that a secure configuration is to be
loaded onto several devices, it is best if this is done from one device. This can be
achieved with the check command:
mod cmd UP1 check <final-command> <serial>
The phone has an internal variable that is initially empty (or empty if the device was
reset with the standard settings) called UPDATE/CHECK. The check command
compares the content of <serial> with the UPDATE/CHECK variable. If both match,
all further processes of the maintenance file are terminated.
If they differ, the remaining processes are executed. When the last process has been
executed, the UPDATE/CHECK variable is overwritten with the content of <serial>,
and the content of <final-command> is executed. The following commands are
usable content for <final-command>
•
ireset
: Resets the device as soon as it is not being actively used.
•
reset
: Resets the device immediately.
•
iresetn
: Resets the device as soon as it is not being actively used and a reset
is required.
•
resetn
: Resets the device immediately if a reset is required.
•
ser
: no-op
4.9.3.1.7 Times Command
Often, configuration changes shall be made only during certain times (e.g. non-
working hours). This can be achieved using the times command:
mod cmd UP1 times [/allow <hours>] [/initial <minutes>]
The times command will check the current time against <hours>. If it does not
match this restriction, any further processing of the command file is cancelled.
<hours> is a comma separated list of hours. Only those hours listed are considered
valid times for execution of the command file.
mod cmd UP1 times /allow 12,22,23,0,1,2,3,4