Emerson Rosemount 5900C, Reference Manual

Page: 231 / 322

Table 6-3: Warning Messages
(continued)
Message Description Action
Other memory warning Input register no. 6106. Contact Emerson Automation
Solutions /Rosemount Tank Gauging
service department
MWM warning Input register no. 6108.
Bit 1: Version mismatch between PM
and RM
RM warning Input register no. 6110
Bit 1: SW config
Bit 5: FPROM Checksum
Bit 6: FPROM Version
Bit 9: HREG Checksum
Bit 10: HREG Limit
Bit 11: HREG Write
Bit 12: HREG Read
Bit 13: HREG Version
Bit 14: MWM Invalid Id
Bit 30: SW Serious Warning
Other hardware warning Input register no. 6122.
Configuration warning Input register no. 6128.
Bit 0: Super Test Active
Bit 1: ATP Table Invalid
Bit 2: Special Correction Table Invalid
Bit 3: Near Zone Correction Table
Invalid
Bit 4: Config Model Code invalid
Bit 5: Config LPG Pins Visible
Bit 6: Config LPG Error
Bit 7: Simulation Mode Used
Bit 8: Default Sweep Mode Used
Bit 9: Test Sweep used
Bit 10: ACT Table Invalid
Bit 11: UCT Table Invalid
Bit 12: Simple Simulation Mode
Warning
Bit 13: Ramp Simulation Mode
Warning
Bit 14: TSM Filter Too Narrow
Bit 15: MMS Offset Update disabled • Load the default database and
restart the level gauge, see
Loading the default database using
TankMaster
™
.
• Configure the level gauge or load a
backup configuration file (see
Recover a backup configuration
database using TankMaster
™
).
• Contact Emerson Automation
Solutions/Rosemount Tank
Gauging service department if the
problem persists.
SW warning Input register no. 6130.
Bit 8: DSP Undefined software warning Contact Emerson Automation
Solutions/Rosemount Tank Gauging
service department
Reference Manual Service and troubleshooting
00809-0100-5901 September 2019
Rosemount 5900C Radar Level Gauge 231