135
Additional settings (ETS)
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
Control modes for drive control
Behaviour on button actuation in standard control mode:
Standard:
If briefly operated, the drive will move incrementally or stops. If operated longer, the
drive will move up to the end position. The time difference between "short" and "long"
is set individually.
Standard inverted:
When pushed shortly, the drive moves up to the end position. When pushed for longer,
the drive moves incrementally or stops. The time difference between "short" and
"long" and the repeat interval is set individually.
Comfort mode:
In the
comfort mode
pushing the button briefly, a bit longer and long will trigger
different responses of the drive. The time intervals are set individually.
By pushing the button (shorter than adjustable time 1) the drive will be positioned
(resp. stopped) incrementally.
On change of
if transmitted on change
0.1°C • ... • 0.5°C • ... • 5.0°C
Transmission cycle
if transmitted periodically
5 s...2 h
Short:
Press and hold:
Shutter
Stop/step
Up
Blind
Up Stop
Awning
Stop
Retract
Window
Stop
Close
Control mode
Standard
Behavior during button operation:
short = stop/increment long = Up or Down
Time between short and long
in 0.1 seconds
1...50; 10
Control mode
Standard inverted
Behavior during button operation:
short = Up or Down long = Stop/Step
Time between short and long
in 0.1 seconds
1...50; 10
Repeat the step command
for a long button press
every 0.1 s • every 2 sec; every 0.5 sec
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
