13
Description
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
1.3.
Addressing the device
The programming mode for addressing at the bus is activated via the programming
button at the back of the housing or via the display.
Settings > System > Service > KNX
1.4.
Setting up the WLAN connection
Only for the
Corlo Touch KNX WL
model with an interface for wireless network
connection!
1.4.1. WLAN settings in the ETS
The WLAN connection must be set up in the ETS. Consult the WLAN setting section in
the manual
ETS: System Settings > WLAN
2.13.1 WLAN
You set the network name and the encryption for compatibility with the WLAN network
access point. The IP address allocation can be made either automatically by DHCP or
manually.
1.4.2. Displaying WLAN status on the display
You can call up information on the current status of the connection on the
Corlo
Touch KNX
display. Network name, signal strength, IP address, DNS address and GW
address are displayed.
Settings > System > Service > WLAN Status
3.11.7. WLAN Status
KNX programmming LED ON:
Programming mode active.
KNX programming LED OFF:
Programming mode off.
The current address is displayed (Address
15.15.250 when delivered).
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
