12
Description
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
Connection overview
Connect the bus voltage (no. 4, red/black terminals) and auxiliary voltage (no. 5,
yellow/white terminals). Use the attached breakout cable for connecting the digital/
analog inputs (no. 7). The cables for the inputs can be extendet to up to 10 m. All GND
connections of the inputs are bridged internally (black cable).
1.2.3. Instructions for assembly and operational
start-up
Never expose the sensor to water (e.g. rain) or dust. This can damage the electronics.
You must not exceed a relative air humidity of 95%. Avoid condensation.
After the operating voltage has been applied, the device will enter an initialisation
phase lasting a few seconds. During this phase no information can be received or sent
via the bus.
Fig. 7
1
Snaplock connector seating
2
Magnets (additional fixing)
3
USB socket
4
KNX terminal bus +/-
5
Terminal auxiliary supply 24 V DC
±10%, terminal configuration
independent from polarity
6
Micro SD socket (card contacts must
show in the direction of the display
when inserting it)
7
Analog/digital inputs socket
8
Programming button for addressing
the device at the bus (recessed)
2
3
4
5
1
6
7
8
Fig. 8
Breakout cable for analog/digital inputs:
Input 1: black/white
Input 2: black/yellow
Input 3: black/lilac
Input 4: black/blue
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
