42
System settings via ETS
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
2.7.
Proximity sensor
The proximity sensor of the
Corlo Touch KNX
registers when an object moves into
the capture range or leaves this range. Consequently, you can send object no. 38 when
approaching the display and object no. 40 when leaving the vicinity of the display.
The object functions for the proximity sensor can only be set via the ETS.
Each of the objects can be configured as a bit object and send the value 1 or 0, or switch
between 0 and 1 (e.g. to switch the light). Alternatively, the object may be configured
as a byte object and send a value between 0 and 255, or a percentage value (e.g. for
dimming lights, approaching a shade position or recalling a scene).
2.8.
Alarm
The six alarm functions of the
Corlo Touch KNX
show messages in the display. At
the same time, the display may flash, and an alarm tone emitted. Alarm messages may
be acknowledged with the button shown on the display or via the bus. For this
purpose, decide whether to use a 1 or a 0 for the acknowledgement.
The alarm functions use objects no. 56-67 (per alarm channel there is one input object
and one input/output object for acknowledgement). They can be modified on the
display or in the ETS menu.
ETS: Alarm
The settings
on the display
are modified via the menu
Settings > system > alarm
and can be secured with an access code (set up in the ETS).
System settings via touch display >
Use objects for proximity sensor
• No
(do not use proximity sensor to transmit
objects)
• Yes
(activate objects 38 and 40)
on approach
Object no. 38 "proximity sensor
approaching"
or
on leaving
Object no. 40 "proximity sensor distancing"
• nothing will be sent
• bit object (value 1) will be transmitted
• bit object (value 0) will be transmitted
• bit object will be switched
• byte object (value 0...255) will be
transmitted
• byte object (value 0...100%) will be
transmitted
Transmission delay in s
(is only transmitted if byte object is
transmitted)
0...240; 2
Value
only upon transmission
0...255; 255 or
0...100; 100
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
