109
Automatic functions
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
Once the indoor temperature sinks again, the lock becomes active as soon as the
temperature
is more than 3°C below the set value (hysteresis).
Please note that the retraction delay is also valid for the indoor temperature lock and
the shade shall only be retracted when the delay time is over.
The
outdoor temperature block
prevents moving extended shades at low outdoor
temperatures. The block is lifted again only when the temperature rises more than 2.0
°C over the pre-set value (hysteresis).
The block applies to the automatic mode only. Even for active outdoor temperature
blocks, the drive reacts to frost, wind and rain alarms and to manual operating
commands.
ATTENTION!
A drive or curtain can be damaged if an external shade which
has frozen stiff is retracted!
Running rails or other mechanical parts may still be iced up although the
outdoor temperature has already risen to quite high degrees.
In order to reliably prevent damage due to ice, use the
frost alarm
function.
Note:
Time coordinated/night closure function and outdoor temperature block.
If the outdoor temperature is below the blocking temperature, shades are
automatically extended, but not retracted any more. If the shade no longer retracts
after the set time period has expired, check whether the blind is frozen or if the running
rails are iced up. If the blind runs freely, re-start the blind manually.
Settings appearing only in case of shading settings saved as applicable
"always":
Select the
movement position
for automatic mode. In case of shutters, you might
also select the slat setting and determine whether the slats are to follow the position
of the sun. If so, we distinguish between four elevation areas which are each assigned
a percentage of slat position.
Use indoor temperature lock
No
• Yes
Allow shading from (in 0.1 °C)
only if block is active
50...400; 220
Use outdoor temperature block
No
• Yes
Allow shading from (in 0.1 °C)
only if block is active
-200...300; 50
Shading
Always
Movement position (in %)
0...100
Slat position
only for shutters
• Does not track the sun
• Tracks the sun
Slat position (in %)
without following the sun position
0...100; 75
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
