96
Automatic functions
Display Corlo Touch KNX
• Status: 09.03.2017 • Technical changes and errors reserved.
Safety notes for automatic functions
WARNING!
Risk of injury due to automatically moved components!
The automatic control may cause parts of the system to travel
and pose a danger to humans.
•
No persons may remain in the travelling range of parts driven
by an electric motor.
•
Adhere to the relevant building regulations (see guideline for
power-operated windows, doors and gates BGR 232 et al).
•
Always disconnect the system from the mains power before
maintenance or cleaning (e.g. switch off/remove fuse).
Precipitation warning for automatically controlled windows:
Some time can pass before falling rain is recognised by the sensors in the system,
depending on the rain amount and outdoor temperature. Furthermore, a closure time
must be calculated for electrically-actuated windows or sliding roofs. Humidity-
sensitive items should therefore not be placed in an area where they might be
damaged by incoming precipitation. Please also bear in mind that in the event of a
power failure and rainfall, a window will not be automatically closed if no emergency
generator is installed.
Running rails of shades icing up:
Note that the rails of shutters, awnings and blind which are externally mounted can ice
up. Operating the drive under such conditions can damage the shades and drives.
5.1.
General automation settings
ETS: Automation
Use the automation menu to allocate functions to the five automatic channels of the
Corlo Touch KNX
.
Furthermore, this menu is used for making general settings:
•
Sun position calculation
•
Access code for automatic menus
•
Supervision of wind/precipitation objects
•
Lock time in case of wind warning
•
Twilight threshold value
•
Extension and retraction delays for shades
•
Opening limitation for windows
•
Ventilation lock during cooling
•
Night-time re-cooling
•
Frost alarm
•
Heat protection temperature
•
Times for automatic reset
Summary of Contents for Corlo Touch KNX 70258
Page 2: ......
