Dell PowerEdge R510, Hardware Owner'S Manual

Page: 44 / 216

44
About Your System
Alert! Power
required exceeds
PSU wattage.
Check PSU and
system
configuration.
Alert!
Continuing
system boot
accepts the risk
that system may
power down
without warning.
The system configuration
of processor(s),
memory modules,
and expansion cards may
not be supported by the
power supplies. If any system components
were just upgraded,
return the system to the
previous configuration.
If the system boots without
this warning, then the
replaced component(s) are
not supported with this
power supply. If Energy
Smart power supplies are
installed, replace them with
High Output power supplies
to use the components.
See "Power Supplies" on
page 109.
Alert! Redundant
memory disabled!
Memory
configuration
does not support
redundant
memory.
Memory Sparing or Memory
Mirroring was enabled in the
system setup program, but
the current configuration
does not support redundant
memory. A memory module
may be faulty. Check the memory modules
for failure. See
"Troubleshooting System
Memory" on page 177.
Reset the memory setting,
if appropriate. See "Using
the System Setup Program
and UEFI Boot Manager" on
page 61.
Alert! System
fatal error
during previous
boot.
An error caused the
system to reboot. Check other system
messages for additional
information for possible
causes.
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.
System is in manufacturing
mode. Reboot to take the system
out of manufacturing mode.
Message Causes Corrective Actions
book.book Page 44 Friday, November 20, 2009 2:56 PM