Dell PowerEdge R510, Hardware Owner'S Manual

Page: 29 / 216

About Your System
29
LCD Status Messages (Optional)
NOTE:
This section is applicable only to eight–hard-drive systems.
The system's control panel LCD provides status messages to signify when the
system is operating correctly or when the system needs attention.
The LCD lights blue to indicate a normal operating condition, and lights
amber to indicate an error condition. The LCD scrolls a message that
includes a status code followed by descriptive text. The table that follows
provides a listing of LCD status messages and the probable cause for each
message. The LCD messages refer to events recorded in the system event log
(SEL). For information on the SEL and configuring system management
settings, see the systems management software documentation.
NOTE:
If your system fails to boot, press the System ID button for at least five
seconds until an error code appears on the LCD. Record the code, then see "Getting
Help" on page 199.
Code Text Causes Corrective Actions
N/A SYSTEM NAME
A 62-character string that
can be defined by the user
in the System Setup
program.
The
SYSTEM NAME
displays under the
following conditions:
• The system is
powered on.
• The power is off and
active errors are
displayed.
This message is for
information only.
You can change the
system ID and name in
the System Setup
program. See "Using the
System Setup Program
and UEFI Boot Manager"
on page 61.
E1000 Failsafe
voltage
error.
Contact
support.
Check the system
event log for critical
failure events. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 199.
book.book Page 29 Friday, November 20, 2009 2:56 PM