Datalogic AMT58 Series, Manual

Page: 295 / 435

AMT58x-CB CANopen®
1
1. Safety summary
Safety

Always adhere to the professional safety and accident prevention
regulations applicable to your country during device installation and
operation;

installation and maintenance operations have to be carried out by
qualified personnel only, with power supply disconnected and stationary
mechanical parts;

device must be used only for the purpose appropriate to its design: use
for purposes other than those for which it has been designed could
result in serious personal and/or the environment damage;

high current, voltage and moving mechanical parts can cause serious or
fatal injury;

failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design,
manufacture, and intended use of the equipment;

Datalogic Automation S.r.l. assumes no liability for the customer's failure
to comply with these requirements.
Electrical safety

Turn off power supply before connecting the device;

connect according to explanation in section“4 – Electrical
connections”.

in compliance with the 2014/30/EU norm on electromagnetic
compatibility, following precautions must be taken:
- before handling and installing, discharge electrical charge from your
body and tools which may come in touch with the device;
- power supply must be stabilized without noise, install EMC filters on
device power supply if needed;
- always use shielded cables (twisted pair cables whenever possible);
- avoid cables runs longer than necessary;
- avoid running the signal cable near high voltage power cables;
- mount the device as far as possible from any capacitive or inductive
noise source, shield the device from noise source if needed;
- to guarantee a correct working of the device, avoid using strong
magnets on or near by the unit;
- minimize noise by connecting the shield and/or the frame to ground.
Make sure that ground is not affected by noise. The connection point to
ground can be situated both on the device side and on user’s side. The
best solution to minimize the interference must be carried out by the
user.