Datalogic AMT58 Series, Manual

Page: 310 / 435

AMT58x-CB CANopen®
16
6.3 Communication objects
Four different kinds of communication messages are used in a
CANopen® network:

Network management NMT protocol: NMT protocols are used to
issue state machine change commands (i.e. to start and stop the
devices), detect remote device boot-ups and error conditions.

Process Data Objects PDO protocol: used to process real time
data (transmission of process data in real time).

Service Data Objects SDO protocol: used to set and read values
from the object dictionary of a remote device.

Special Function Objects:
- SYNC: synchronization message used by master to enable
slaves devices to transmit process data (encoder position and
velocity).
- Emergency: error messages are triggered by each error event.
- Nodeguard: used to request the state of the slave.
Relation between device states and communication objects:
Initial. Pre-oper. Operat. Stopped
NMT X X X
PDO
X
SDO X X
SYNC X
EMCY X X
Boot-up X
Node
guard
X X X
6.3.1 Pre-defined connection set
Master

Slave broadcast
Type of COB
(Object)
Function code
(binary)
COB-ID (hex)
NMT 0000 000
SYNC 0001 080
peer-to-peer transmission
EMERGENCY 0001 081 - 0FF
PDO 1 (tx) 0011 181 - 1FF
PDO 2 (tx) 0101 281 - 2FF
PDO 3 (tx) 0111 381 - 3FF
PDO4 (tx) 1001 481 - 4FF
SDO (tx) 1011 581 - 5FF
SDO (rx) 1100 601 - 67F
Node guard 1110 701 - 77F
Boot-up 1110 701 - 77F
The type of COB (tx or rx) is viewed from the slave device.