Datalogic AMT58 Series, Manual

Page: 193 / 435

INSTRUCTION MANUAL
13
CHAPTER 5
GETTING STARTED
QUICK START INFORMATION
The following instructions allow the operator to quickly and safely set up the device in a
standard operational mode.
For complete and detailed information please read the mentioned pages thoroughly.
• Mechanically install the device, see
Mechanical Installation, starting on page 4
;
• execute the electrical and network connections, see
Electrical Connections, starting
on page 7
;
• switch on the +10Vdc +30Vdc power supply;
• install the GSDML file, see "
Installing the GSDML file" on page 20
;
• insert the Datalogic module and type of telegram in the PROFINET-IO system, see
"
Adding a node to the project" on page 21
;
• set the device name, see "
Setting the device name and the IP address" on page 26
;
• set the IP address and the subnet mask to the node, see "
Setting the device name
and the IP address" on page 26
; the default address is 0.0.0.0 ;
• to set the parameters, enter the
Module parameters
page, see "
Module parame -
ters" on page 24
; in this page it is possible, for example, to set the singleturn reso -
lution or the total resolution, to enable the scaling function or to change the
counting direction; after entering new values, you must download the parameters
to the device; for the complete list of the default parameters see
Default Parame -
ter List, starting on page 103
;
• to enable the scaling function, change the counting direction and execute the pre -
set, the Class 4 functionality parameter must be enabled (=”1”), see "
Class 4 func -
tionality" on page 64
.
NOTE
It is possible to configure the parameters also by entering the web server
via browser (see "
Integrated Web Server" on page 90
): in the Set Encoder
Registers page (see "
Setting the Parameters" on page 94
), the operator can
either enter the desired value or set it through the drop-down box in the
input field under the WRITE column; then he has to press the button
between the boxes to confirm. The value that is currently set can be found
in the box on the right under the READ column.